AT HOME

Charging with an AC Cable

- Plug the charging cable into a wall outlet, then connect the other side to the AC Input Port (17) of the portable power station. You will see the charging state (3) in the LCD display if connected properly.

Only recharge with the charger cable supplied by Go Power!

WITH SOLAR

Charging with an optional solar panel (Max Charging Power - 120W)

- Place the solar panel in direct sunlight

- Connect the solar panel with the solar charging cable. Plug the cable into the solar charging port (17) on the side of the portable power station. You will see the charging indicator on the LCD display (3).

- The integrated solar charge controller will stop charging when the battery is fully charged.

Solar input should not exceed 22v. Go Power! recommends using a DuraLite Expansion Panel to charge the DuraCUBE.