2496
SYSTEM OVERVIEW & MOUNTING REQUIREMENTS FOR THE SW INVERTER 1500TS
Typical System Overview
The following diagrams show how the GP-SW1500TS and GP-SWR-A (or B) Remote are typically installed in a mobile RV application. The diagrams show where the remote and Inverter are installed and how the mobile power system can be integrated with a Go Power! RV Solar Kit (sold separately by Go Power, please contact us direct.)
Mounting Requirements
1. TEMPERATURE
Make sure the GP-SW1500TS is installed in a location where the normal air temperature is between -20°C and 40°C. The cooler the better within this range.
2. MOISTURE
Do not allow water or other fluids to come into contact with the GP-SW1500TS. Do not expose to rain, snow or water.
3. VENTILATION
For optimum Inverter performance the GP-SW1500TS must be installed so the front and rear air vents are not blocked or obstructed in any way. Do not install the GP-SW1500TS in an area with limited air flow. Allow as much space around the Inverter as possible, leaving at least 6” of airspace clearance around all ventilation areas.
CAUTION! Equipment Damage. Do not mount the GP-SW1500TS in a zero clearance compartment. Do not cover the ventilation openings. Overheating and mechanical failure may occur.
4. FIRE
Install the GP-SW1500TS away from the battery bank, away from any flammable or combustible material (paper, flammable liquids, gasoline, cloths) that may be ignited by heat, sparks or flames. Never place the Inverter directly above the battery bank - gases from the batteries will corrode and damage the Inverter, never allow battery acid to drip onto the unit.
5. ACCESSIBILITY / ORIENTATION
Do not block access to the GP-SW1500TS remote control access port, status LEDs and the On/Off switch. Allow enough room to access the AC and DC wiring terminals and connections as they will need to be checked and tightened periodically. The GP-SW1500TS must be installed in one of the approved mounting orientations detailed on page 21. DO NOT MOUNT VERTICALLY.
6. CLEAN
The GP-SW1500TS should be installed in a location which is clean and limits the introduction of dust, fumes, insects or rodents which could enter and block the Inverter ventilation openings.
7. PROXIMITY TO BATTERY BANK
The GP-SW1500TS should be located as close to the batteries as possible but not within the same compartment. The length and size of the DC Cables will affect performance. Long DC wires tend to lose efficiency and reduce the overall performance of the Inverter/Charger.
Mounting
