2010
GPSW-150 Front
a. AC outlet: Outlet sockets available: North America (NEMA 5-15R)
b. ON / OFF switch: Power ON/OFF switch, leave in the OFF position during installation.
c. Remote port: Allows customer to connect 2 wire switch to use as ON/OFF remote. Ex. Toggle switch or light switch.
d. Power status LED: The LED display indicates the power status of the inverter:
- Solid Green: AC power OK
- Fast Red Blink: Over voltage protection (OVP)
- Slow Red Blink: Under voltage protection (UVP) Intermittent
- Red Blink: Over temperature protection (OTP)
- Solid Red: Overload protection (OLP)
GPSW-150 Rear
WARNING: Operation of the inverter without a proper ground connection may result in an electrical safety hazard.
a. Ventilation port: Do not obstruct, allow at least 1 inch (2.54 cm) for air flow.
b. Connect the chassis ground to the vehicle chassis using a #8 AWG wire.
c. DC Input: Included: 3 foot (0.91 m) cable with automobile DC plug.
Use the DC input terminal to connect to a battery or other power source: black is negative (–), red is positive (+).
A reverse polarity connection will blow the internal fuse and may permanently damage the inverter. Observe the DC Input rating.
GPSW-300 Front
a. ON / OFF switch: Power ON/OFF switch, leave in the OFF position during installation.
b. AC outlet: Outlet sockets available: North America (GFCI).
c. Remote port: Allows customer to connect 2 wire switch to use as ON/OFF remote. Ex. Toggle switch or light switch.
d. Power status LED: The LED display indicates the power status of the inverter:
- Solid Green: AC power OK
- Fast Red Blink: Over voltage protection (OVP)
- Slow Red Blink: Under voltage protection (UVP) Intermittent
- Red Blink: Over temperature protection (OTP)
- Solid Red: Overload protection (OLP)
GPSW-300 Rear
WARNING: Operation of the inverter without a proper ground connection may result in an electrical safety hazard.
a. Ventilation port: Do not obstruct, allow at least 1 inch (2.54 cm) for air flow.
b. Connect the chassis ground to the vehicle chassis using a #8 AWG wire.
c. DC Input: Included: 3 foot (0.91 m) cable with automobile DC plug.
Use the DC input terminal to connect to a battery or other power source: black is negative (–), red is positive (+).
A reverse polarity connection will blow the internal fuse and may permanently damage the inverter. Observe the DC Input rating.
