ECLIPSE SERIES: CABLE ENTRY PLATE - OPTION 3
1. Remove the rubber sealing caps from the ends of the MC4 connectors in the CEP. 2. Plug the Positive and Negative MC4 Connectors from the solar panels directly into the CEP. 3. Locate the positive and negative cables exiting the CEP and route these to the GP-RVC30-MPPT Solar Charge Controller.
ECLIPSE SERIES: REFRIGERATOR VENT ACCESS - OPTION 1
1. Locate the refrigerator vent on the roof of the RV. Remove vent cover to gain access to the duct opening. 2. Drill a hole through the side of the vent (5/8” hole). 3. Remove any sharp edges from the hole. 4. Insert a rubber grommet (not included) into the hole. 5. Insert the MC4 Positive and Negative Extension…
ECLIPSE SERIES: MOUNTING FEET
4. Assemble 4 mounting feet onto each of the solar panels frame using the 1/4” bolts and nuts. This assembly is easily completed on the ground before the panels are brought up to the RV roof. (See Figure 4-A) WARNING: • The mounting feet must be installed on the 4 outer holes in the panel frame. • All 4 mounting…
ECLIPSE SERIES: CONNECT THE SOLAR CHARGE CONTROLLER TO THE BATTERY BANK
It is recommended to connect directly to the battery whenever possible. You can also connect to the converter/charger where the battery positive and negative wires connect to the converter/charger 1. Clean all corrosion from the battery terminals before proceeding 2. Crimp ring terminals onto the positive and neg…
ECLIPSE SERIES: REFRIGERATOR VENT ACCESS - OPTION 2
1. Locate the refrigerator vent on the roof of the RV. Remove vent cover to gain access to the duct opening. 2. Thread MC4 Positive and Negative Extension Cables carefully through the screen and into opening. 3. Enlarge screen grid hole if necessary. 4. Remove any sharp edges from the hole. 5. Avoid strapping the…
ECLIPSE SERIES: DISCLAIMERS
IMPORTANT: Please follow installation and wiring instructions exactly as outlined to ensure safety. We recommend installation by an RV technician or professional electrician to ensure adherence to relevant electrical codes. We have made every reasonable effort to ensure the accuracy of the instructions in this manua…
ECLIPSE SERIES: MAINTENANCE
INSPECTION After installing any Go Power! Solar Kit or any other Go Power! products, all modules, electrical and mechanical components and connections should be inspected annually by a trained Go Power! or dealer representative or other qualified personnel for safe electrical and mechanical connections and to ensu…
ECLIPSE SERIES: INITIAL CONNECTION AND OPERATING
1. Check all electrical connections and ensure all cables are securely fastened 2. Install the Fuse into the fuse holder, ensure the fuse holder is securely fastened 3. Remove the opaque material from the solar panels 4. Follow the solar charge controller user manual and operating steps
