ECLIPSE SERIES: MOUNTING FEET
4. Assemble 4 mounting feet onto each of the solar panels frame using the 1/4” bolts and nuts. This assembly is easily completed on the ground before the panels are brought up to the RV roof. (See Figure 4-A) WARNING: • The mounting feet must be installed on the 4 outer holes in the panel frame. • All 4 mounting…
ECLIPSE SERIES: CONNECT THE SOLAR CHARGE CONTROLLER TO THE BATTERY BANK
It is recommended to connect directly to the battery whenever possible. You can also connect to the converter/charger where the battery positive and negative wires connect to the converter/charger 1. Clean all corrosion from the battery terminals before proceeding 2. Crimp ring terminals onto the positive and neg…
ECLIPSE SERIES: REFRIGERATOR VENT ACCESS - OPTION 2
1. Locate the refrigerator vent on the roof of the RV. Remove vent cover to gain access to the duct opening. 2. Thread MC4 Positive and Negative Extension Cables carefully through the screen and into opening. 3. Enlarge screen grid hole if necessary. 4. Remove any sharp edges from the hole. 5. Avoid strapping the…
ECLIPSE SERIES: MAINTENANCE
INSPECTION After installing any Go Power! Solar Kit or any other Go Power! products, all modules, electrical and mechanical components and connections should be inspected annually by a trained Go Power! or dealer representative or other qualified personnel for safe electrical and mechanical connections and to ensu…
ECLIPSE SERIES: DISCLAIMERS
IMPORTANT: Please follow installation and wiring instructions exactly as outlined to ensure safety. We recommend installation by an RV technician or professional electrician to ensure adherence to relevant electrical codes. We have made every reasonable effort to ensure the accuracy of the instructions in this manua…
ECLIPSE SERIES: WARRANTY
WARRANTY LENGTH The Go Power! warranty is valid against defects in materials and workmanship for the specific product warranty period. It is not valid against defects resulting from, but not limited to: • Misuse and/or abuse, neglect or accident • Exceeding the unit’s design limits • Improper installation, in…
ECLIPSE SERIES: INITIAL CONNECTION AND OPERATING
1. Check all electrical connections and ensure all cables are securely fastened 2. Install the Fuse into the fuse holder, ensure the fuse holder is securely fastened 3. Remove the opaque material from the solar panels 4. Follow the solar charge controller user manual and operating steps
ECLIPSE SERIES: PLAN YOUR SOLAR SYSTEM SETUP
1. Take a few minutes before commencing any installation work to layout your solar system on paper first. Use the diagrams within the manual (pages 20-27) to help. 2. Complete a simple block diagram identifying the key components and connections of your Solar charging system: Solar Panels, MC4 Positive and Negative …
